Buying and Maintaining Pool Sand Filters

Pool sand filters are one of the most important equipment you should have when you have a swimming pool. This will remove all unwanted dirt particles such as sand from the pool to keep it clean and sparkling. The working process of pool sand filters works just like coffee makers. Water is pulled down into the filter pipe and as it passes through the filter, sand, debris, and unwanted dirt will be filtered by the pool sand filters. The certainty of the durability of the pool sand filters depends on how you maintain it.

There are ways for you to maintain your pool sand filters. One method in pool sand filters maintenance is by backwashing the filters. Backwashing filters are done depending on the type of use of the pool. Public pools are required to do backwashing of pool sand filters every two to three days, while backyard or private pools depend on how it is usually used. When doing maintenance on your pool, you must at all time wear safety goggles in order for you to avoid accidents. Here are some steps and tips in backwashing your pool sand filters.

One important thing is to check and know the flow of the water. The water flows through the pump trap basket. This is where large debris is filtered. After the pump basket, the water then passes through the sand filters before the water is pushed out back to the pool. It is also important to check the filter pipes and pump system before the process of backwashing begins.

Turn off the pump and check all baskets to make sure that no large debris has passed. Large debris may damage pool sand filters which is quite a common reason to damage the sand filters. Upon checking, remove all large debris like leaves and other solid objects.

Turn the pump on and switch to backwash. Let the pump continue until the water in the slight glass is clear. Turn it off again and set the pump to rinse, and let it pump until the water is clear again.

Turn the pump off again and check for debris that may have been cleaned by the filter during backwash. Replace the basket and turn the lid tight and secured.

Adjust the pump into filtering position. After all the procedure is done in sequence, the filter is now totally clean and will operate more effectively.

In doing this process, it is essential to know and check the pH of the chlorine level of the pool. The proper pH level is 7.2 to 7.8, while the chlorine level is between 1.0 to 2.0 ppm.

In the process of wear and tear you need to purchase another set of pool sand filters. There are tips to be done to ensure good and quality filters. Here are some of them.

First is to know what type of pool sand filters the pool is using. There are two categories: the in-ground and the above-ground filters.

Know the size and sand capacity of the filters you are going to use.

Buy wholesale filters in order to have plenty of reserve filters in case of wear and tear replacement.

Sand filters for pool are better purchased in bulk because in bulk purchasing the prices of pool sand filters are much discounted and therefore it becomes cheaper and affordable.